CUMMINS ED-3 Guia do Utilizador

9The ALARM PAGE is a pop-up window that displays the list of all current active faults. Alarms are listed in reverse chronological order. The most re

Alarm Page (Key 5)When an alarm is present, the display will bleep and the “Active Fault Present” banner will flash over the screen on every page. Whil

Navigation between pagesPressing one of these keys will display a pop-up window. Pressing the same key again will select the next item in the list. Pr

13View group (VIEW – Key 1)This group allows the display of available data in different formats. As in the BASIC PAGE, pressing Key 4 can configure eac

Bulkhead Installation● Decide on a location.● Allow adequate clearance behind the unit for the cable connection to ensure the cable is not undu

2 23APPENDIXElectronic Display ConnectionsWhen using SAEJ1708/ J1587 communication protocol the display requires four wires to operate: two for power

Table of ContentsElectronic Display Description 4Power On Screen 5Initial Setup 6Default Screen (BASIC PAGE) 8Changing the engine parameter to be

21Electronic Display DescriptionThe ED-3 Electronic Display is an LCD display with 5 menu keys that can display engine parameters in a variety of form

Power On ScreenThis power on screen will be shown when power is first applied to the unit. The display will perform a self-test for proper operation of

19Initial SetupOn initial power up the display will automatically enter screens within the Settings and Config Menus which need to be set up by the us

If J1939 is selected, the user must also enter J1939 Settings menu and select the engine source (this is not necessary if J1587 is selected). Every de

Menu Exit (MENU EXIT – Key 5)When no active faults are present, this key allows clearing of the menu bar from the screen as well as adjusting display