CUMMINS N14 Especificações descarregar pdf (Página 108)

100

101

The accompanying chart lists the different cam follower

housing gaskets, the gasket thickness, and approximate

change in push rod travel at 19 degrees BTDC 0.2032-

inch piston travel.

NOTE: The Print-O-Seal gasket (1) must be against the

cylinder block with the sealing bead toward the cam follower

housing. The minimum amount of gasket stack-up thickness

which can be used is 0.43 mm [0.017-inch] (one Print-O-Seal

gasket). The maximum gasket stack-up thickness allowed is

2.03 mm [0.080-inch].

If you can not correct the injection timing by increasing

or decreasing the thickness of the cam follower housing

gaskets (1), an offset camshaft key (2) must be installed.

The timing code specifies the required camshaft key. An

offset key can be required initially.

After completing the injection timing check on cylinder

No. 1, check the injection timing on cylinders No. 5 and

No. 3.

Cam Follower Housing Gaskets

Gasket

Part No.

Thickness

[mm] Inch

Change in

Push Rod Travel

At 19° BTDC

[mm] Inch

3020000

(Print-O-Seal)

0.36 to 0.51

[0.014 to 0.020]

0.09 to 0.13

[0.0035 to 0.005]

3020001 0.15 to 0.20

[0.006 to 0.008]

0.04 to 0.05

[0.0015 to 0.002]

3020002 0.36 to 0.51

[0.014 to 0.020]

0.09 to 0.13

[0.0035 to 0.005]

3020003 0.51 to 0.61

[0.020 to 0.024]

0.13 to 0.15

[0.005 to 0.006]

3020004 0.69 to 0.84

[0.027 to 0.033]

0.18 to 0.20

[0.007 to 0.008]

Injection Timing - General Information Engine Assembly (00-02)

N14Page 0-88

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 108

Comentários a estes Manuais