CUMMINS N14 Especificações descarregar pdf (Página 237)

100

101

Caution: Wear protective gloves when handling parts

that have been heated to prevent personal injury.

Heat the gear in an oven at 260°C [500°F] for a minimum

of 1 hour.

Remove the gear from the oven.

NOTE: Install the gear on the camshaft within 30 seconds

after it is removed from the oven.

Caution: The timing marks and the part number on the

gear must be facing away from the camshaft when the

gear is installed to prevent engine damage.

Align the gear keyway with the key in the camshaft, and

install the gear.

NOTE: Keep the camshaft in a vertical position with the gear

up until the gear has cooled.

Caution: Do not use water or oil to reduce the cooling

time. The gear can crack. Allow the air to cool the gear.

If the gear does not seat against the locating shoulder on

the camshaft, remove the gear and install it again.

Use a feeler gauge to check the clearance between the

camshaft gear and the shoulder. The clearance must not

exceed 0.13 mm [0.005-inch].

Gear Cover - Cleaning and Inspection

(01-19)

Cleaning

Use a mallet and a mandrel or a drift to remove the front

crankshaft seal and the accessory drive seal.

Cylinder Block Gear Cover - Cleaning and Inspection (01-19)

N14 Page 1-69

1 2 ... 232 233 234 235 236 237 238 239 240 241 242 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 237

Comentários a estes Manuais