CUMMINS N14 Especificações descarregar pdf (Página 217)

100

101

Measure the rod length and bend (alignment).

Connecting Rod Length

mm in

304.75 MIN 11.998

304.80 MAX 12.000

Connecting Rod Alignment

mm in

Bushing Removed 0.25 MAX 0.010

Bushing Installed 0.10 MAX 0.004

Twist - Inspection

Using a feeler gauge, check the clearance between the

mandrel and the dial indicator holding plate as shown.

Connecting Rod Twist

mm in

Bushing Removed 0.50 MAX 0.020

Bushing Installed 0.25 MAX 0.010

Connecting Rod Bearings - Cleaning

and Inspection (01-10)

NOTE: The bearings must be marked for location as they are

removed for future identification. Each bearing must be

installed in its original location if the bearing is used again.

Cleaning

Caution: Do not use a scraper or a wire brush. The bear-

ings can be damaged.

Use solvent and a soft bristle brush. Dry with compressed

air.

Inspection

Visually inspect the bearings for damage.

Replace any bearings with the following damage:

• Pitting

• Flaking

• Corrosion

• Lock tang damage

• Scratches (deep enough to be felt with a fingernail)

Refer to the Parts Reuse Guidelines, Bulletin No. 3810303,

for further information.

Cylinder Block Connecting Rod Bearings - Cleaning and Inspection (01-10)

N14 Page 1-49

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 217

Comentários a estes Manuais