CUMMINS N14 Especificações descarregar pdf (Página 502)

100

101

The dowel must be long enough to protrude from the

block one-half of the flywheel housing wall thickness but

must not protrude past the housing wall.

NOTE: There are three oversize dowel pins available:

Oversize Dowel Pin O.D.

Overall Dimension Amount Oversize

mm in mm in

13.08 [0.515] 0.38 [0.015]

13.46 [0.530] 0.76 [0.030]

13.84 [0.545] 1.14 [0.045]

Install the appropriate drill bushings. The Table shows

the bushings available in Part No. 3376495.

The drill bushing used must be the same size as the

reamer (or the drill) which is used.

If the new dowel pins are more than 0.38 mm [0.015-inch]

larger than the old dowels, drill the hole to a size that is

slightly smaller than the reamer. Then the reamer will not

have to remove an excessive amount of material.

Caution: Do not allow metal chips to enter the engine.

Damage to the engine will result.

Ream the hole until the reamer touches the bottom of the

hole in the block.

Drill/Ream Bushing Set

25.4 mm [1 inch] O.D.

Oversize

[inch]

Bushing

Size

Bushing

Size

[inch]

3376495 Special 12.304 [0.4844]

Standard 12.700 [0.5000]

0.38 [0.015] 13.096 [0.5156]

0.76 [0.030] 13.494 [0.5312]

1.14 [0.045] 13.879 [0.5464]

Mounting Adaptations Flywheel Housing - Redowel to Cylinder Block (16-04)

N14 Page 16-11

1 2 ... 497 498 499 500 501 502 503 504 505 506 507 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 502

Comentários a estes Manuais