CUMMINS N14 Especificações descarregar pdf (Página 240)

100

101

Measure the gear cover accessory drive bushing bore.

Accessory Drive Bushing Bore I.D.

mm in

43.07 MIN 1.696

43.10 MAX 1.697

NOTE: Replace the gear cover if the bore is not within

specifications or if the bore is cracked or damaged.

Use gear cover bushing mandrel, Part No. ST-598, to

install a new accessory drive bushing.

Align the oil hole (1) in the bushing with the oil drilling in

the front cover. Use a mallet or an arbor press to install

the bushing. Support the opposite side of the cover.

Use a 3.17 mm [0.125-inch] diameter rod to check the

position and the location of the oil hole in the bushing and

the gear cover.

The rod must pass through the oil hole in the bushing and

into the oil supply drilling in the gear cover.

Rear Cover - Cleaning and Inspection

(01-20)

Use a mandrel or drift to remove the crankshaft oil seal.

Rear Cover - Cleaning and Inspection (01-20) Cylinder Block

N14Page 1-72

1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 240

Comentários a estes Manuais