CUMMINS N14 Especificações descarregar pdf (Página 321)

100

101

Assembly

NOTE: The roller pin must be installed correctly to make

sure the cam follower roller and the roller pin are supplied

with oil. Inspect the new roller pin as shown to determine the

oil feed pass (1) and the alignment hole (2) locations. The oil

feed passage is drilled approximately two-thirds of the way

through the pin. The alignment hole is drilled completely

through the pin.

Use a grease pencil or a similar marker to draw a line on

the side of the roller pin that is perpendicular to the

alignment hole.

NOTE: The line will help align the roller pin correctly in the

cam follower lever.

Install the cam follower lever in an arbor press with the

leg with the alignment hole towards the top.

Install the roller into the cam follower lever.

Caution: Use the largest feeler gauge that will fit be-

tween the roller and the lever to prevent leg deflection

when installing the roller pin. This will reduce shaving of

the bronze roller pin and prevent leg breakage.

Install a feeler gauge between the roller and the leg of the

lever.

• Valve cam follower lever (A)

• Injector cam follower lever (B)

Cam Follower Assembly Cam Follower Lever - Roller Replacement (04-03)

N14 Page 4-15

1 2 ... 316 317 318 319 320 321 322 323 324 325 326 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 321

Comentários a estes Manuais