CUMMINS N14 Especificações descarregar pdf (Página 154)

100

101

Water Pump Belt - Installation and

Adjustment

Visually inspect the pulley alignment. Pulley misalign-

ment must not exceed 0.5 mm per cm [1/16-inch per foot]

of distance between the pulley centers.

Inspect and repair or replace the idler pulley or water

pump if pulley misalignment exceeds 0.5 mm per cm

[1/16-inch per foot].

Install a new belt on the pulleys.

Turn the adjusting screw to adjust belt tension.

NOTE: Belt tension can increase when the lock nut is tight-

ened. Do not adjust belt tension to full value with the ad-

justing screw.

Use Part No. ST-1293 (Borroughs) or 3822525 (Click-

Type) Belt Tension Gauge to measure six-rib belt tension.

New Belt Tension Used Belt Tension*

710 N [160 lb] 580 N [130 lb]

* A belt is considered used if it has been in operation

for 10 minutes or longer.

Tighten the idler pulley shaft lock nut.

Torque Value: 68 N•m [50 ft-lb]

Loosen the adjusting screw 1/2-turn to prevent breakage.

Measure the belt tension again. Adjust if necessary.

Water Pump Belt - Installation and Adjustment Engine Assembly (00-02)

N14Page 0-134

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 154

Comentários a estes Manuais