CUMMINS N14 Especificações descarregar pdf (Página 196)

100

101

Clean and flush the newly cut threads with safety solvent,

Part No. 3823717. Use a chip removing unit to clean the

capscrew hole of shavings and debris, and allow to dry.

Lightly spray the threads with LoctiteT Primer-T, Part No.

ST-1272-13, and allow to dry.

Prepare the thread insert for installation. Put the jam nut

on a cylinder head capscrew. Install the repair insert on

the capscrew until it contacts the jam nut.

Clean and flush the outside diameter of the repair insert

with safety solvent and allow to dry. Lightly spray with

LoctiteT Primer-T, Part No. ST-1272-13, and allow to dry.

Apply four beads of sealant, Part No. 3823718, to the

outside diameter of the closed end thread insert. The

beads of sealant must be approximately 1/32-inch wide

and 90 degrees apart. Each bead must be the full length

of the external threaded portion of the insert.

Cylinder Block - Machining (01-03) Cylinder Block

N14Page 1-28

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 196

Comentários a estes Manuais