CUMMINS N14 Especificações descarregar pdf (Página 187)

100

101

Use a 0.08 mm [0.003-inch] feeler gauge that is not more

than 13 mm [0.5-inch] wide.

Center the checking ring in the bore. Try to put the feeler

gauge between the checking ring and the bore. Rotate

the gauge in the bore at both sides of the checking ring.

The bore alignment of the main bearing is okay if:

• the gauge does not enter at any point.

• the gauge will enter but will not slide through or

around the bore and the alignment bar will rotate

with the gauge inserted.

The bore alignment of the main bearing is not okay if:

• the gauge enters and slides around the bore. This

means that the bore is oversize and must be re-

paired.

• the gauge will enter on one side only but can slide

around the bore. This means that the bore is ta-

pered and must be repaired.

If the tools to check the main bearing bore alignment are

not available, use a dial bore indicator to measure the

main bearing bore inside diameters.

NOTE: This procedure does not check main bearing bore

alignment but will identify bore diameters that do not meet

specifications.

NOTE: Support the rear portion of the block on a flat surface

to obtain the most accurate measurement of the inside

diameter.

Cylinder Block Cylinder Block - Cleaning and Inspection (01-02)

N14 Page 1-19

1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 187

Comentários a estes Manuais