CUMMINS N14 Especificações descarregar pdf (Página 155)

100

101

Thermostat Housing - Installation

Install the water transfer tube with new o-rings into the

water pump housing. Apply a non-petroleum based lu-

bricant such as soap or vegetable oil to the o-rings on

each end of the tube and to the bores in the water pump

housing and the thermostat housing cover.

Install the thermostat housing assembly and mounting

gasket on the rocker lever housing and onto the water

transfer tube.

Install the four mounting capscrews and washers.

Tighten the capscrews.

Torque Value: 47 N•m [35 ft-lb]

CELECT™ Coolant Temperature Sensor

- Installation

Make sure the sensor has an o-ring. Install the sensor in

the engine. Tighten the sensor.

Torque Value: 34 N•m [25 ft-lb]

Push the electrical connector into the sensor until it locks

in place.

Air Compressor Coolant Inlet and

Outlet Tubes - Installation

NOTE: If rubber grommets are used on the coolant lines, be

sure they are installed carefully to prevent cuts or tears to

the grommets which will cause coolant leaks. When flexible

tubing is used, make sure that it does not rub any other

surfaces.

Engine Assembly (00-02) Thermostat Housing - Installation

N14 Page 0-135

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 155

Comentários a estes Manuais