CUMMINS N14 Especificações descarregar pdf (Página 214)

100

101

Measure the connecting rod bearing bore inside diame-

ter.

Connecting Rod Crankshaft Bore I.D.

mm in

93.731 MIN 3.6902

93.769 MAX 3.6917

If any of the measurements are not within the specifica-

tions, the rod must be repaired or replaced.

Measure the piston pin bushing inside diameter.

Piston Pin Bushing I.D.

mm in

63.525 MIN 2.5010

63.581 MAX 2.5032

If the bushing does not meet the specifications, the rod

must be replaced.

Caution: The connecting rod must be assembled with

the capscrews tightened to specifications before stamp-

ing identification numbers or alpha characters on the

rod.

If a new connecting rod is installed, always check the rod

and cap assemblies identification to make sure it does

not match any of the other rod and cap assemblies in that

engine. If it does, the rod and cap must be stamped so

they can be differentiated from the other rod and cap

assemblies.

Refer to the Alternate Repair Manual, Bulletin No.

3379035, for procedures to magnetically check for cracks

in the connecting rods and capscrews.

Connecting Rod Assemblies - Cleaning and Inspection (01-08) Cylinder Block

N14Page 1-46

1 2 ... 209 210 211 212 213 214 215 216 217 218 219 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 214

Comentários a estes Manuais