CUMMINS N14 Especificações descarregar pdf (Página 87)

100

101

Install the pins in crankshaft oil seal driver, Part No.

ST-997.

Use crankshaft oil seal driver, Part No. ST-997, to install

the oil seal in the rear cover.

Flywheel Housing - Installation

Caution: If a new flywheel housing is being installed,

the dowels must be removed from the cylinder block

prior to installing the housing to prevent damage to the

housing. The housing must be doweled with an oversize

dowel after it has been aligned. Refer to Flywheel Hous-

ing - Redowel to Cylinder Block (16-04).

Install two 5/8-18 x 4-inch guide studs in the cylinder

block to help support and align the housing during

installation.

If a wet-type flywheel housing is being installed, do the

following:

1. Install a new o-ring on the rear cover. Use vegetable

oil to lubricate the o-ring.

2. Install 11 rectangular sealing rings in the capscrew

dowel pin counterbores in the flywheel housing. Use

gasket adhesive to fasten the sealing rings to the

housing.

Install the flywheel housing over the guide studs.

Install the capscrews, and tighten in the sequence shown.

Torque Value: 203 N•m [150 ft-lb]

Engine Assembly (00-02) Flywheel Housing - Installation

N14 Page 0-67

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 87

Comentários a estes Manuais