CUMMINS N14 Especificações descarregar pdf (Página 199)

100

101

Install the camshaft bushings in the following order: No.

7, No. 6, No. 5, No. 4, No. 3, No. 2, and No. 1.

Bushing (No. 7) - Installation

An alignment pointer, Part No. 3823635, is used to align

the cam bearing oil holes with the oil holes in the block.

To use, mount the bearing on the driver. Place the align-

ment pointer against the machined side of the block at the

cam follower holes with the end of the rod at the top of the

bearing. Rotate the cam bearing until the seam of the

bearing is at the end of the rod. Press the cam bearing

in as described.

Install the bushing marked No. 7 on the driver with the

location notch to the rear of the engine and at the 6:00

o’clock position.

Push the bushing into the bore until the oil holes in the

bushing are aligned with the drillings in the bore.

Use a 2.39 mm [0.094-inch] diameter rod or a 3/32-inch

hexagon wrench to check the position and the location of

the oil hole in the bushing and the cylinder block.

The rod must pass through the oil holes in the bushing

and into the oil supply drillings in the cylinder block.

Cylinder Block Cylinder Block - Assembly (01-05)

N14 Page 1-31

1 2 ... 194 195 196 197 198 199 200 201 202 203 204 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 199

Comentários a estes Manuais