CUMMINS N14 Especificações descarregar pdf (Página 363)

100

101

Turn the adjusting knob clockwise to push the tool bit

against the indicator tip.

NOTE: Adjust the tool bit until the indicator is set to the same

size as the setting standard.

Tighten the set screw and remove the adjusting knob.

Install the boring tool into the guide bushing.

NOTE: The tool bit must go through the slot in the guide

bushing. Do not allow the tool bit to hit against the guide

bushing.

Adjust the travel of the boring bar so the tool bit will go

through the guide bushing but does not touch the bush-

ing in the oil pump body.

Use capscrews to fasten the boring tool to the oil pump

body.

Rotate the boring tool shaft to make sure it will turn freely.

NOTE: The pump and the boring tool must be in a vertical

position. Make sure the boring tool can cut completely

through the bushings.

Move the feed control lever to the ‘‘ON’’ position.

NOTE: This will prevent the drive shaft from moving down.

Install the drive adapter into a heavy duty 3/8-inch drill

motor, and engage the adapter with the drive shaft of the

boring tool.

Lubricating Oil System Lubricating Oil Pump Body and Cover Bushing - Replacement (07-07)

N14 Page 7-21

1 2 ... 358 359 360 361 362 363 364 365 366 367 368 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 363

Comentários a estes Manuais