CUMMINS N14 Especificações Página 95

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 587
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 94
Install the flywheel, and inspect the bore runout again.
Replace the flywheel if the runout does not meet
specifications.
Face Alignment - Measurement
Install the contact tip of the indicator against the flywheel
face, as close to the outside diameter as possible, to
inspect the face (4) runout.
Push the flywheel forward to remove the crankshaft end
clearance. Adjust the dial on the indicator until the needle
points to ‘‘0.’’
Rotate the crankshaft one complete revolution. Measure
the flywheel runout at four equal points on the flywheel.
NOTE: The flywheel must be pushed toward the front of the
engine to remove the crankshaft end clearance each time
a point is measured.
Engine Assembly (00-02) Flywheel - Installation
N14 Page 0-75
Vista de página 94
1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..