CUMMINS N14 Especificações descarregar pdf (Página 499)

100

101

Measure and record the diameter of one of the dowel pins

which was removed to determine the next oversize dowel

to be installed after the housing is aligned.

Install the flywheel housing without the dowel pins.

Tighten the capscrews.

Torque Value: 7 N•m [5 ft-lb]

NOTE: Do not tighten the capscrews to the final torque

value until the flywheel housing is aligned.

Use chalk to mark the housing at the 12:00 o’clock, 3:00

o’clock, 6:00 o’clock, and 9:00 o’clock positions.

Attach the dial indicator to the crankshaft as shown.

Use the accessory drive to rotate the crankshaft until the

dial indicator is at the 3:00 o’clock position. Adjust the dial

indicator until the needle points to ″0.″

Rotate the crankshaft until the indicator is at the 9:00

o’clock position. Check the total indicator reading.

Flywheel Housing - Redowel to Cylinder Block (16-04) Mounting Adaptations

N14Page 16-8

1 2 ... 494 495 496 497 498 499 500 501 502 503 504 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 499

Comentários a estes Manuais