CUMMINS N14 Especificações descarregar pdf (Página 394)

100

101

Prepare the drive pulley bore surface with LocktiteW

Primer T, Part No. ST-1272-13.

Apply a light film of LocktiteW 609, Part No. 3823718, to

the bore in the drive pulley.

Support the water pump pulley in an arbor press. Push

the water pump shaft into the pulley bore until the pulley

is against the large diameter (shoulder) of the shaft.

Prepare the impeller bore surface with LocktiteW Primer

T, Part No. ST-1272-13.

Apply a light film of LocktiteW 609, Part No. 3823718, to

the bore in the impeller.

Support the pulley end of the water pump shaft in an arbor

press. Push the impeller onto the shaft until the end of the

impeller hub is aligned with the end of the shaft.

As a final inspection, turn the water pump pulley by hand

to inspect the bearings for freedom of rotation.

NOTE: If the water pump shaft does not rotate freely in the

water pump body, the water pump must be disassembled,

inspected, and assembled again.

Water Pump Idler Assembly - Cleaning

and Inspection (08-03)

Cleaning

Warning: When using a steam cleaner, wear protective

clothing and safety glasses or a face shield. Hot steam

can cause serious personal injury.

NOTE: Do not apply steam directly to the face of the

bearing seal.

Use solvent or steam to clean the idler assembly exterior.

Dry with compressed air.

Water Pump Idler Assembly - Cleaning and Inspection (08-03) Cooling System

N14Page 8-14

1 2 ... 389 390 391 392 393 394 395 396 397 398 399 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 394

Comentários a estes Manuais