CUMMINS N14 Especificações descarregar pdf (Página 215)

100

101

Connecting Rod Ring Dowels - Removal

Caution: Do not damage the surface or the ring dowel

hole during removal of the dowel.

Use pliers or locking pliers to remove the damaged ring

dowels.

Use a blunt punch, if necessary, to bend the ring in for

removal.

Connecting Rod Ring Dowels - Installation

Caution: Do not use a hammer or damage to the dowel

will result.

Use a plastic mallet to install the ring dowel.

Connecting Rods - Bend and Twist

Inspection (01-09)

Fixture Calibration

Use a connecting rod checking fixture, Part No. ST-561,

and a connecting rod mandrel set, Part No. 3823785, to

inspect the bend and the twist of the rods.

Calibrate the checking fixture with a new rod that has

been measured for correct center to center length, 304.75

mm to 304.80 mm [11.998 inches to 12.000 inches].

NOTE: Assemble the connecting rod cap to the rod as

described in Connecting Rods - Inspection.

Install the piston pin mandrel from the connecting rod

mandrel set, Part No. 3823785, into the piston pin bore.

NOTE: Use a mandrel, Part No. 3823787, if the piston pin

bushing has been removed or the mandrel, Part No.

3823788, if the bushing is still in place.

Install the mandrel, Part No. 3823786, into the crankshaft

bore and expand the mandrel.

NOTE: Make sure the pin on the mandrel is pointed down

and locked in position in the center of the connecting rod.

Cylinder Block Connecting Rods - Bend and Twist Inspection (01-09)

N14 Page 1-47

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 215

Comentários a estes Manuais