CUMMINS N14 Especificações descarregar pdf (Página 362)

100

101

Assembly

Use bushing mandrel, Part No. ST-1158, to push the new

bushings into the oil pump body and cover.

NOTE: The bushings must be installed level with or no more

than 0.51 mm [0.020-inch] below the surface of the oil pump

body or cover.

Use lubricating oil pump boring tool, Part No. 3375206,

to cut the bore in the new bushings in the oil pump body

and the cover.

Install the guide bushing into the gear pocket.

Tighten the capscrew against the side of the gear pocket

to hold the guide bushing in position.

Install the dial indicator into the setting block.

Install the setting block on the setting standard.

Adjust the dial indicator.

NOTE: The indicator tip must be set on the diameter size of

the new bushing bore to be cut.

Bushing I.D. (New)

mm in

22.28 MIN 0.877

22.30 MAX 0.878

Install the tool bit into the boring bar.

NOTE: Do not completely tighten the set screw.

Install the tool bit adjusting knob into the boring bar.

NOTE: Hold the setting block and the indicator against the

boring bar so the indicator tip will be over the tool kit.

Lubricating Oil Pump Body and Cover Bushing - Replacement (07-07) Lubricating Oil System

N14Page 7-20

1 2 ... 357 358 359 360 361 362 363 364 365 366 367 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 362

Comentários a estes Manuais