
Remove the dipstick and scribe a mark across the dipstick.
Mark the ‘‘LOW’’ level with an ‘‘L.’’
NOTE: The dipstick will break if the scribe mark is too deep.
NOTE: Cut the new dipstick off approximately 38 mm [1.5
inches] below the ‘‘LOW’’ oil level mark.
Install the dipstick into the dipstick tube housing.
Use clean 15W-40 oil to fill the oil pan to the specified
‘‘HIGH’’ oil pan capacity level.
Refer to the preceding oil pan capacity table for the oil
required.
Remove the dipstick and scribe a mark across the dipstick.
Mark the ‘‘HIGH’’ oil level with an ‘‘H.’’
NOTE: The dipstick will break if the scribe mark is too deep.
Lubricating Oil Pump - Cleaning and
Inspection for Reuse (07-05)
Cleaning
Remove the cover and the gasket from the power steer-
ing pump mounting flange.
Use a gasket scraper to remove the gasket material from
the gasket mating surfaces.
Use solvent to clean the lubricating oil pump. Dry with
compressed air.
Lubricating Oil Pump - Cleaning and Inspection for Reuse (07-05) Lubricating Oil System
N14Page 7-10
Perfect..