CUMMINS N14 Especificações descarregar pdf (Página 114)

100

101

Crankshaft Seal, Front - Installation

NOTE: ‘‘LDL TFE’’ (Lay-down Lip, Teflon) oil seals for ser-

vice replacement have an assembly tool which protects the

seal lip during shipment and installation. The ‘‘LDL TFE’’ oil

seal must be installed with the lip of the seal and the crank-

shaft clean and dry. Do not use any kind of lubricant. The

use of lubricant will result in oil leakage at the seal.

Use hand pressure to push the oil seal from the assembly

tool onto the crankshaft as far as possible. Remove the

assembly tool.

Install top plate, Part No. ST-1259-1, (from oil seal puller/

installer, Part No. ST-1259) on the crankshaft; and use

three vibration damper mounting capscrews and flat

washers.

Tighten the three capscrews alternately in 1/2 turn in-

crements until top plate, Part No. ST-1259-1, seats against

the crankshaft nose.

Remove the oil seal puller/installer, Part No. ST-1259.

Camshaft Bearing Support - Installa-

tion

Install the support bearing in the bore of the gear cover.

Do not install the o-ring on the support at this time.

Push the support against the camshaft so the camshaft

gear rests against the camshaft thrust washer.

Hold the support against the camshaft, and use a feeler

gauge to measure the space between the gear cover

flange and the support bearing.

Crankshaft Seal, Front - Installation Engine Assembly (00-02)

N14Page 0-94

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 114

Comentários a estes Manuais