CUMMINS N14 Especificações descarregar pdf (Página 184)

100

101

Use two centering rings, Part No. ST-1177-39 [4.750

inches diameter]. Put the rings in the No. 2 and the No.

6 main bearing locations.

Use clean 15W-40 oil to lubricate the main bearing cap-

screw threads and the flat washers.

Drain the excess oil from the capscrews before installing

them.

Caution: The main bearing caps are marked for position

(1) on the camshaft side and the cylinder block identi-

fication (2) on the exhaust side. The cylinder block iden-

tification number (3) is stamped on the pan rail on the

camshaft side of the block. Install the caps in the correct

position with the position number to the camshaft side

and its part number toward the rear of the engine.

Install the main bearing caps as follows:

1. Align the capscrew holes in the cap with the holes in

the cylinder block.

2. Install the capscrews and the washers through the cap

and into the cylinder block.

3. Use your hand to tighten the capscrews two to three

threads.

Cylinder Block - Cleaning and Inspection (01-02) Cylinder Block

N14Page 1-16

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 184

Comentários a estes Manuais