CUMMINS N14 Especificações descarregar pdf (Página 368)

100

101

Measure the inside diameter of the new bushings in the

driven gear.

Bushing I.D. (New)

mm in

22.28 MIN 0.877

22.30 MAX 0.878

NOTE: The bushings used in the driven gear are finished

bushings and do not require cutting. If the bushing inside

diameter is not within the specifications given after instal-

lation, the bushing must be replaced.

Lubricating Oil Pump Drive Gear or

Shaft - Replacement (07-09)

Disassembly

To remove the drive shaft from the drive gear, do the

following:

1. Install the shaft and the gear assembly in an arbor

press.

2. Use a mandrel to push the shaft from the gear.

Inspection

Visually inspect the bore in the drive gear for damage.

Measure the inside diameter of the bore in the drive gear.

Drive Gear Bore I.D.

mm in

22.187 MIN 0.8735

22.200 MAX 0.8740

NOTE: If the bore inside diameter is not within specifica-

tions, the gear must be replaced.

Visually inspect the drive shaft for damage.

Measure the outside diameter of the drive shaft.

Drive Shaft O.D.

mm in

22.212 MIN 0.8745

22.225 MAX 0.8750

NOTE: Shafts that are damaged or worn smaller than the

minimum given must be replaced.

Lubricating Oil Pump Drive Gear or Shaft - Replacement (07-09) Lubricating Oil System

N14Page 7-26

1 2 ... 363 364 365 366 367 368 369 370 371 372 373 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 368

Comentários a estes Manuais