CUMMINS N14 Especificações descarregar pdf (Página 318)

100

101

Install the levers and the shafts in the housings.

NOTE: To prevent increased wear, install the cam follower

levers and the shafts back in their original location in the

housing.

Install the cup plugs in the housings as follows:

1. Install two temporary capscrews in the shafts to pre-

vent breaking the locking screws.

2. Put cup plug sealant, Part No. 3375068, on the cup

plugs.

3. Use expansion plug driver (1), Part No. 3376813, to

install the cup plugs. Install to a depth of 0.025 inch ±

0.010 inch below flush.

4. Remove the two temporary capscrews, and install the

two locking screws in the shafts.

Torque Value: 2 N•m [15 in-lb]

NOTE: The heads of the locking screws must be flush or

below flush with the gasket surface of the cam follower

housing.

Cam Follower Lever - Roller Replace-

ment (04-03)

Disassembly

Install the cam follower lever into a vise with brass jaws.

The cam follower lever does not have a through hole in

which to drive the roll pin for removal.

Use a hammer and cam follower pin driver, Part No.

3823592, or a suitable pin punch to drive the roll pin out

of the lever (1) and into the roller pin (2).

Cam Follower Lever - Roller Replacement (04-03) Cam Follower Assembly

N14Page 4-12

1 2 ... 313 314 315 316 317 318 319 320 321 322 323 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 318

Comentários a estes Manuais