CUMMINS N14 Especificações descarregar pdf (Página 80)

100

101

Use a depth gauge, Part No. 3823495, to measure the

liner protrusion at four points 90 degrees apart. The pro-

trusion must be from 0.10 mm to 0.18 mm [0.004-inch to

0.007-inch].

If correct liner protrusion is not attained, remove the liner

from the cylinder block.

Check the following for causes of incorrect liner protru-

sion:

1. Check for twisted liner o-rings.

2. Incorrect liner sealing ring thickness.

3. Clean the liner flange and the cylinder block liner

counterbore.

4. Inspect the liner flange for burrs.

5. Inspect the cylinder block liner counterbore for burrs.

Remove the burrs, or replace the damaged parts.

Install the liner again. Check the liner protrusion again.

If protrusion is still not correct, refer to the N14 Trouble-

shooting and Repair Manual, Bulletin No. 3810456, Sec-

tion 7, ‘‘Counterbore Ledge Measurement and

Machining.’’

Cylinder Liners - Installation Engine Assembly (00-02)

N14Page 0-60

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 80

Comentários a estes Manuais