CUMMINS N14 Especificações descarregar pdf (Página 454)

100

101

Use an air tank (2). Install an air regulator (3) capable of

maintaining 345 to 517 kPa [50 to 75 psi] air pressure at

both minimum and maximum engine RPM.

Install a steel tube or high temperature hose (1).

Hose Temperature (Minimum): 235°C [500°F].

Connect the tube or hose (1) to the air compressor outlet.

NOTE: Inspect the voltage rating on the starting motor be-

fore installing the electrical wiring.

Install the electrical wiring to the starting motor and bat-

teries, if used.

NOTE: If another method of starting the engine is used,

follow the manufacturer’s instructions to make the neces-

sary connections.

Electronic Hookup - CELECT™ Engines Only

When testing a CELECT™ engine on an engine dyna-

mometer, it is necessary to attach a throttle input control,

and a 12 volt power supply to the ECM.

A Compulink™ must also be used to bypass certain fea-

tures and programmed parameters associated with the

CELECT™ ECM while the engine run-in or performance

test is in process.

The engine dynamometer OEM harness for both the N14

and L10 engines are the same. The CELECT™ dyna-

mometer test OEM wiring harness, Service Tool Part No.

3823948, is available through Cummins. The harness is

supplied with all necessary connections and switches.

Items not supplied are the remote throttle actuator and

the 12 volt battery.

Engine Dynamometer - Install Engine (14-01) Engine Testing

N14Page 14-14

1 2 ... 449 450 451 452 453 454 455 456 457 458 459 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 454

Comentários a estes Manuais