CUMMINS N14 Especificações descarregar pdf (Página 419)

100

101

Use a fine grit emergy cloth dipped in clean lubricating oil

to remove minor defects.

Use a crocus cloth for final polishing operation and to

remove any remaining deposits on the pulley wear sleeve

mounting boss.

Clean the wear sleeve mounting boss with a clean cloth.

Measure the pulley wear sleeve mounting boss outside

diameter.

Wear Sleeve Fit Area O.D.

mm in

50.77 MIN 1.999

50.82 MAX 2.001

Installation

Support the accessory drive pulley in an arbor press.

Install the wear sleeve on the pulley seal wear surface

with the chamfer on the outside diameter of the wear

sleeve facing up (away from the pulley).

Place a flat steel plate on top of the wear sleeve. Press the

sleeve on the pulley until the steel plate contacts the

pulley.

Inspect the wear sleeve for damage or burrs.

Drive Units Accessory Drive Pulley Wear Sleeve - Replacement (09-05)

N14 Page 9-15

1 2 ... 414 415 416 417 418 419 420 421 422 423 424 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 419

Comentários a estes Manuais