CUMMINS N14 Especificações descarregar pdf (Página 365)

100

101

Install the boring bar through the guide bushing.

NOTE: The tool bit must go through the slot in the guide

bushing. Do not allow the tool bit to hit against the guide

bushing.

With the feed control level in the ‘‘OFF’’ position, move

the drive shaft down until the tool bit touches the bushing

in the cover.

Hold a new bushing and a 1.57 mm [0.062-inch] feeler

gauge against the drive shaft at the top of the boring tool

body.

Move the stop collar down against the feeler gauge and

tighten the set screw.

Move the feed lever to the ‘‘ON’’ position.

Remove the feeler gauge and the bushing.

Lubricating Oil System Lubricating Oil Pump Body and Cover Bushing - Replacement (07-07)

N14 Page 7-23

1 2 ... 360 361 362 363 364 365 366 367 368 369 370 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 365

Comentários a estes Manuais