CUMMINS N14 Especificações descarregar pdf (Página 121)

100

101

If injector puller, Part No. 3823579, is not available, a

screwdriver can be used to install the injector by putting

the screwdriver on the injector body at the base of the

injector solenoid and striking the screwdriver with a soft

mallet. Do not strike on the injector solenoid or on the top

stop spring cage.

Warning: The injector must be fully seated before in-

stalling the hold down clamp. The hold down clamp can

not pull the injector into the bore. Engine damage can

occur if the injector is not fully seated.

Install the hold down clamp capscrew.

Torque Value: 54 N•m [40 ft-lb]

STC Engines

Install the oil manifold connector using new o-rings. Lu-

bricate the o-rings and the rocker housing bores with

vegetable oil. Also lubricate the internal jumper tube and

o-ring and carefully align them with the external manifold

connector during assembly. A snap will be felt as the oil

manifold connector seats into the rocker lever housing.

Install the two mounting capscrews and tighten.

Torque Value: 24 N•m [18 ft-lb]

Install the internal oil tube using a new grommet seal and

new o-rings. Lubricate the o-rings with vegetable oil.

Engine Assembly (00-02) Injectors - Installation

N14 Page 0-101

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 121

Comentários a estes Manuais