CUMMINS N14 Especificações descarregar pdf (Página 392)

100

101

Use water pump bearing mandrel, Part No. ST-658, to

support a new outer bearing. Install the shaft and the

spacer into the bearing.

NOTE: Push the shaft through the bearing until the bearing

is against the spacer. Make sure the inner race of the bear-

ing is not overloaded from contact with the spacer. The

bearings must rotate freely.

Install a new inner oil seal and a new slinger onto the

shaft.

Use seal expander, Part No. 3823885, to install the seal.

Use water pump slinger driver, Part No. 3823816, to

press the slinger to the proper location.

Prepare the outside diameter surface of the bearing with

LocktiteW Primer T, Part No. ST-1272-13.

Apply a thin film of LocktiteW 609, Part No. 3823718, to

the outside diameter of the bearings.

Support the impeller side of the water pump body in an

arbor press. Use water pump mandrel, Part No. ST-658,

to install the bearing and shaft assembly in the water

pump body.

Install the retaining ring into the groove in the water pump

body.

NOTE: The flat side of the bearing retaining ring must be

installed toward the bearing.

Water Pump Assembly - Rebuild (08-02) Cooling System

N14Page 8-12

1 2 ... 387 388 389 390 391 392 393 394 395 396 397 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 392

Comentários a estes Manuais