CUMMINS N14 Especificações descarregar pdf (Página 64)

100

101

Use a liquid metal marker to mark the cylinder number on

each liner.

If the sealing rings were removed, do the following:

1. Use a tag to mark the cylinder number.

2. Measure in several places and record the thickness of

the sealing rings used in each cylinder. The thickness

of the sealing ring is one factor in determining liner

protrusion. This information must be known when the

liners are installed in the engine.

Crankshaft - Removal

Caution: The main bearing caps must be marked for

position and cylinder block identification.

The position number (1) of the cap is stamped on the

camshaft side and the block identification number (2) is

stamped on the exhaust side of the cap.

The cylinder block identification number is stamped on

the front and the rear of the oil pan flange on the camshaft

side of the engine.

Check and mark all caps that are not marked before

removing them from the cylinder block.

NOTE: The No. 7 main bearing cap has thrust bearings and

dowel pins.

Remove the main bearing capscrews and the washers.

Crankshaft - Removal Engine Disassembly (00-01)

N14Page 0-44

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 64

Comentários a estes Manuais