CUMMINS N14 Especificações descarregar pdf (Página 185)

100

101

4. Hit the cap with a rubber mallet to push it into the

correct position.

NOTE: The main bearing caps must not have any side

clearance with the block.

Cylinder Block to Main Bearing Cap Press Fit

mm in

0.03 MIN 0.001

0.15 MAX 0.006

Put the checking ring into the cylinder block main bearing

saddle. Put the main bearing cap over the checking ring.

Tighten the main bearing cap capscrews to the following

torque values in the sequence shown:

1. Tighten to 120 N•m [90 ft-lb].

2. Tighten to 230 N•m [170 ft-lb].

3. Tighten to 345 N•m [255 ft-lb].

4. Loosen completely.

5. Repeat steps No. 1 through No. 3.

Use clean 15W-40 oil to lubricate the bores of the two

centering rings, Part No. ST-1177-39, and the checking

bar, Part No. ST-1177-16.

Cylinder Block Cylinder Block - Cleaning and Inspection (01-02)

N14 Page 1-17

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 185

Comentários a estes Manuais