CUMMINS N14 Especificações descarregar pdf (Página 81)

100

101

Piston and Connecting Rod Assem-

blies - Assembly and Installation

Install a new snap ring in one of the snap ring grooves of

the piston pin bore on each piston.

Heat the pistons in boiling water for 15 minutes or in an

oven for 30 minutes at 100° C [212° F].

Use clean 15W-40 oil to lubricate the connecting rod

piston pin bore and the piston pin.

Caution: Use insulated gloves to prevent injury from the

boiling water or the heated piston.

Remove the piston from the water or the oven.

Align the pin bore of the rod with the pin bore of the piston,

and install the piston pin. Do not use a hammer to install

the piston pin. The piston will be damaged.

NOTE: The cylinder number of the piston top (1) must be

toward the bearing tang (2) side of the rod.

Install a new snap ring in the second piston pin bore snap

ring groove. The snap ring must be seated completely in

the snap ring groove.

Engine Assembly (00-02) Piston and Connecting Rod Assemblies - Assembly and Installation

N14 Page 0-61

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 81

Comentários a estes Manuais