CUMMINS N14 Especificações descarregar pdf (Página 201)

100

101

Use a 2.39 mm [0.094-inch] diameter rod or a 3/32-inch

hexagon wrench to check the position and the location of

the oil hole in the bushing and the cylinder block.

The rod must pass through the oil holes in the bushing

and into the oil supply drillings in the cylinder block.

Bushing (No. 1) - Installation

NOTE: Camshaft bushing guide, Part No. ST-1228-6, is not

used to install the No. 1 bushing.

An alignment pointer, Part No. 3823635, is used to align

the cam bearing oil holes with the oil holes in the block.

To use, mount the bearing on the driver. Place the align-

ment pointer against the machined side of the block at the

cam follower holes with the end of the rod at the top of the

bearing. Rotate the cam bearing until the seam of the

bearing is at the end of the rod. Press the cam bearing in

as described.

Use a 2.39 mm [0.094-inch] diameter rod or a 3/32-inch

hexagon wrench to check the position and the location of

the oil holes in the bushing and the cylinder block.

The rod must pass through the oil holes in the bushing

and into the oil supply drillings in the cylinder block.

Measure the inside diameter of the installed camshaft

bushings.

Camshaft Bushing I.D. Installed

mm in

63.457 MIN 2.4983

63.558 MAX 2.5023

NOTE: If any of the bushings is not within specification, the

bushing must be replaced.

Cylinder Block Cylinder Block - Assembly (01-05)

N14 Page 1-33

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 201

Comentários a estes Manuais