CUMMINS N14 Especificações descarregar pdf (Página 236)

100

101

Installation

NOTE: The accompanying chart lists different camshaft key

part numbers, the degree of offset, and the approximate

injector timing change from nominal.

Use a plastic mallet to install the camshaft gear key.

NOTE: If the same camshaft and gear are used again, use

the same part number key as the one that was removed.

Make sure the arrow on the key is pointing in the same

direction as when it was removed.

Refer to the engine dataplate and the Control Parts List

Manual, Bulletin No. 3379133, for the correct key part

number and key orientation.

Put the camshaft in a vertical position with the gear fit

area (nose) pointing up.

Apply LubriplateT 105 or its equivalent to the camshaft

gear fit area before installing the gear.

Camshaft Keys

3/4 Inch

Key

Part No.

Offset

mm [Inch]

Timing

Change

Change in

Push Rod

Travel At

19°BTDC

mm [Inch]

3021601 None None None

3021595 0.15 [0.0060] Retard 0.07 [0.0030]

3021593 0.19 [0.0075] Retard 0.09 [0.0037]

3021592 0.29 [0.0115] Retard 0.14 [0.0057]

3021594 0.47 [0.0185] Retard 0.23 [0.0092]

3021596 0.65 [0.0255] Retard 0.32 [0.0127]

3021598 0.79 [0.0310] Retard 0.39 [0.0155]

3021597 0.99 [0.0390] Retard 0.49 [0.0195]

3021600 1.30 [0.0510] Retard 0.65 [0.0255]

3021599 0.29 [0.0115] Advance 0.14 [0.0057]

3024697* 0.65 [0.0255] Advance 0.32 [0.0127]

* For CELECT™ Engines

Camshaft Gear - Replacement (01-18) Cylinder Block

N14Page 1-68

1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 236

Comentários a estes Manuais