CUMMINS N14 Especificações descarregar pdf (Página 62)

100

101

Remove the upper rod bearing.

Mark the cylinder number and the letter ‘‘U’’ in the flat

surface of the bearing tang.

Caution: Do not over expand the piston rings. Maximum

gap at assembly is 1.63 inches.

Use the piston ring expander, Part No. 3823871, to re-

move the piston rings.

Put a tag on the rings, and record the cylinder number of

the piston on the tag for future reference (if required).

Use internal snap ring pliers to remove the snap rings

from both sides of the piston.

Caution: Do not use a hammer to remove the piston

pins. The piston can distort and cause the piston to seize

in the liner.

Use a blunt tool to push the piston pin from the piston and

rod assembly.

Cylinder Liners - Removal

Caution: The liner puller must be installed and used as

described to avoid damage to the cylinder block.

When using cylinder liner puller, Part No. 3376015, insert

the liner puller in the top of the cylinder block.

NOTE: The liner puller must be centered on the top of the

cylinder block. The feet on the extension arms must be

extended below the bottom of the liner.

Cylinder Liners - Removal Engine Disassembly (00-01)

N14Page 0-42

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 586 587

Comentários a estes Manuais

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificações Página 62

Comentários a estes Manuais