
Cylinder Head - Replacing the Injector
Sleeves (02-07)
Disassembly
Use an injector sleeve puller, Part No. ST-1244, to remove
the injector sleeves from the cylinder head.
Install the puller in the injector sleeve with the legs of the
bridge against the cylinder head.
Install the driver, Part No. ST-1244-8, against the large nut
on the puller as shown.
Hit the driver with a mallet to push the forming collar into
the injector sleeve.
Remove the driver from the puller.
Tighten the small nut.
Torque Value: 65 N•m [50 ft-lb]
Turn the large nut clockwise to pull the injector sleeve
from the cylinder head.
Loosen the nuts, and remove the old injector sleeve from
the puller.
Cleaning and Inspection
Remove the injector sleeve o-ring from the injector bore
in the cylinder head. Discard the o-ring.
Use solvent to clean the injector bore. Dry with com-
pressed air.
Visually inspect the grooves (steps) in the bottom of the
injector bore.
Cylinder Head Cylinder Head - Replacing the Injector Sleeves (02-07)
N14 Page 2-31
Perfect..